Great Plains SS2000 Operator Manual - Manual (Page 13)

05/17/2013 Table of Contents Index 596-222M
Great Plains Manufacturing, Inc. Table of Contents Index 9
Introduction
Great Plains welcomes you to our growing family of new
product owners. The Sub-Soiler Inline Ripper SS1800 &
SS2000, 6-12 shank, have been designed with care and
built by skilled workers using quality materials. Proper
setup, maintenance, and safe operating practices will
help you get years of satisfactory use from the machine.
Models Covered
See “SS1800-SS2000 Specifications and Capacities”
on page 22 for precise swath information.
Description of Unit
The Sub-Soiler Inline Ripper SS1800 & SS2000 is a
three-section machine. It is designed to break up soil
crust on hard dried fields while eliminating compaction
layers. An optional berm conditioner may be added to the
rear of each shank.
Document Family
Using This Manual
This manual will familiarize you with
safety, assembly, operation, adjust-
ments, troubleshooting, and mainte-
nance. Read this manual and follow
the recommendations to help ensure safe and efficient
operation.
The information in this manual is current at printing.
Some parts may change to assure top performance.
Definitions
The following terms are used throughout this manual.
A crucial point of information related to the preceding topic.
Read and follow the directions to remain safe, avoid serious
damage to equipment and ensure desired field results.
Note: Useful information related to the preceding topic.
Right-hand and left-hand as used in
this manual are determined by facing
the direction the machine will travel
while in use unless otherwise stated.
An orientation rose in some line art
illustrations shows the directions of:
Up, Back, Left, Down, Front, Right.
SS1800 30”-centers, 7 shank, 3-section
SS1800 36”-centers, 6 shank, 3-section
SS1800 38”-centers, 6 shank, 3-section
SS1800 40”-centers, 6 shank, 3-section
SS2000 24”-centers, 8 shank, 3-section
SS2000 24”-centers, 10 shank, 3-section
SS2000 24”-centers, 12 shank, 3-section
SS2000 30”-centers, 8 shank, 3-section
SS2000 30”-centers, 9 shank, 3-section
SS2000 30”-centers, 10 shank, 3-section
SS2000 36”-centers, 7 shank, 3-section
SS2000 36”-centers, 8 shank, 3-section
SS2000 38”-centers, 7 shank, 3-section
SS2000 38”-centers, 8 shank, 3-section
SS2000 40”-centers, 7 shank, 3-section
Figure 1
SS1800 Sub-Soiler
41827
L
R
U
D
F
B
L
R
596-222M Operator Manual (this document)
596-222P Parts Manual
U
D
F
B
L
R