Clarion DXZ948RMP - Manual (Page 43)

DXZ948RMP
43
English
Operations Common to Each Mode
4. Press the [A] button to return to the original
mode.
Setting the auto-dimmer
(DIMMER IN)
This function allows you to dim the lighting of
the display matched to the illumination or the
brightness inside your car.
Select either “AUTO” (interlocked to the
brightness inside your car) or “ILLUMI”
(interlocked to the illumination inside your car)
as the auto-dimmer setting.
• When the auto-dimmer function is set to
“AUTO”, the brightness of the display is
dimmed according to the brightness detected
by this sensor.
• Set the dimmer setting at DMR LEVEL.
• The factory default setting is “AUTO”.
1. Press the [A] button to set to the adjust
mode.
2. Touch on the setting item display to
select “DIMMER IN” under “APPERNCE”.
ADJUST MODE
DIMMER IN AUTO
APPERNCE
3. Either touch on the right of the
display, or turn the [ROTARY] knob to select
“AUTO” or “ILLUMI”.
4. Press the [A] button to return to the original
mode.
Setting the dimmer level
(DMR LEVEL)
This function allows you to set how much the
displayed is to be dimmed.
• The factory default setting is “3”.
1. Press the [A] button to set to the adjust
mode.
2. Touch on the setting item display to
select “DMR LEVEL” under “APPERNCE”.
ADJUST MODE
DMR LEVEL 3
APPERNCE
3. Either touch on the right of the
display, or turn the [ROTARY] knob to set
the dimmer level.
∗ Select one of OFF (dimming OFF, bright),
1 (slightly dimmed) to 5 (dark).
4. Press the [A] button to return to the original
mode.
Adjusting the contrast of the
display (CONTRAST)
You can adjust the contrast of the display to
match the mounting angle of the unit.
• The factory default setting is “6”.
1. Press the [A] button to set to the adjust
mode.
2. Touch on the setting item display to
select “CONTRAST” under “APPERNCE”.
3. Either touch on the right of the
display, or turn the [ROTARY] knob to adjust
the contrast.
ADJUST MODE
CONTRAST 6
APPERNCE
* This setting item can be adjusted within
the range 1 to 11.
Adjust this setting item while viewing how
the appearance of the display changes.
4. Press the [A] button to return to the original
mode.
Making the LED blink when
DCP is removed (BLINK LED)
You can make the LED on this unit blink when
the DCP is removed.
• The factory default setting is “OFF”.
1. Press the [A] button to set to the adjust
mode.
2. Touch on the setting item display to
select “BLINK LED” under “APPERNCE”.
ADJUST MODE
LED BLINK OFF
APPERNCE