Prepare tie point holes, Identify baffle locations, Identify eyebolt locations – Great Plains 2025P-16TR30 Assembly Instructions User Manual
Page 3: Fb l r
Great Plains Mfg., Inc.
Installation Instructions
3
02/15/2010
118-255M
Prepare Tie Point Holes
Identify Baffle Locations
Baffles are symmetrical left-to-right, but are shaped for a
specific front-to-back orientation.
Select four (4) new:
Temporarily position these wider covers
over the
unused meter wells in between the three inner pairs
of seed tubes in each box.
8.
Select two (2) new:
817-807C 25FT 7 1/2 TO 30TR SPAC COVER
Note that these baffles have “807” molded in.
Temporarily position these narrower covers
over
the unused meter wells in between the two outside
pairs of seed tubes in each box.
Identify Eyebolt Locations
Refer to Figure 4 (showing both suitable eyebolt locations on
one side of a baffle - only one eyebolt per side is installed)
9.
Select one (1) new:
804-007C WASHER FLAT 1/4 SAE PLT
This is used as a template for marking holes.
For use, prepared baffles (
straps which take a diagonal path across the top of the
baffle (the dotted double-arrow line in the Figure). They
attach to eyebolts supplied in this kit, which are installed
in the nearest corners (
,
) of the adjacent seed box
wells.
Depending on vintage, your drill may or may not have
bolts
in suitable locations. If it does, these bolts may
be replaced with the eyebolts in this kit (holes are drilled
otherwise).
10. Check the seed tube wells immediately adjacent to
the baffles. Suitable hole locations are in the cor-
ners closest (
,
) to the baffle. Do not use the
outside corners
(this can cause the strap to inter-
fere with the sliding seed tube, as well as obstruct
seed flow).
Mark any bolt heads at suitable locations. At the
diagonally opposite location, mark any bolt head
there, or use the washer to mark a hole location.
If there are no suitable existing holes on a side,
chose a location. Slide the washer
ner. Use the washer hole as a template to mark the
hole location.
11. Remove all baffles
and
.
Save the washer
Figure 3
Baffle Locations
29559
F
B
L
R
Left Seed Box
Right Seed Box
Figure 4
Bolt Hole Requirement
29556
0
1
U
D
F
B
L
R