Great Plains 2600-2S Assembly Instructions - Manual

1
Assembly Instructions
Great Plains Mfg., Inc.
© Copyright 2000 Printed 2/28/2006
Used with:
•
•
Flat Fold Marker Assembly
Figure 1
15692
Before You Start
These option assembly instructions contain only information on
assembling the attachment to the main unit. A detailed Opera-
tor’s Manual was supplied with the main unit when it was pur-
chased. For more specific information on safety concerns refer to
the Operator’s Manual. Also included in the Operator’s Manual is
important information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some of these sections do
not apply to all options).
A separate Parts Manual for replacement parts can be pur-
chased from your dealer. Have model and serial numbers handy
when placing an order.
Manual Part Numbers:
• 3000-3S 30’ 3 Sec. Drill Operator’s Manual . . . . . .195-110M
• 3000-3S 30’ 3 Sec. Drill Parts Manual . . . . . . . . . . 195-110P
• 2600-2S 26’ 2 Sec. Drill Operator’s Manual . . . . . .195-200M
• 2600-2S 26’ 2-Sec. Drill Parts Manual . . . . . . . . . . 195-200P
General Information
These option assembly instructions apply to the marker bundles
listed below:
113-552A 3000-2600 Left Hand Flat Fold Marker Pkg. 96
113-553A 30' 3-Section Dual Flat Fold Marker Package 96
113-044A 3000-2600 Right Hand Flat Fold Marker Pkg
Starting on page 5 is a detailed listing of parts included in these
kits. Use this list as a checklist to inventory parts received.
Assembly Instructions
Marker Assembly
NOTE: If installing right hand marker package to drill al-
ready equipped with left hand marker, follow instructions
listed under "Dual Flat Fold Marker Hydraulic Assembly."
Refer to Figure 1:
1.
Place drill in a lowered (field) position. From each end of drill
box allow 16 ft. clearance for marker assembly.
Before mounting to drill with fertilizer attachment see “Drill
with Fertilizer Attachment” on page 4.
2. Attach marker first section and mount assembly (1) to wing
box frame. Marker mount should be assembled as far out-
board on frame as possible. This places center of mount
plate the distance (A) from end of box frame. Fasten mount
with 5/8" x 6" x 7 3/4" u-bolts (18), 5/8" lock washers (19),
and 5/8 hex nuts (20). Place
marker first section in hori-
zontal position by removing
port plugs in hydraulic cylin-
ders and completely extend-
ing cylinder rods. Always
assemble marker in unfold-
ed position.
113-561M
3000-3S and 2600-2S
Marker Option
3000-3S 30’ 3-Section Folding Drill
2600-2S 26’ 2-Section Folding Drill
When you see this symbol, the subsequent instructions
and warnings are serious - follow without exception. Your
life and the lives of others depend on it!
!!