Cabletron Systems FDDI - Manual (Page 22)

Chapter 3: Installation/Removal
3-4 7F06-02 FDDI SmartSwitch Interface Module User’s Guide
3.3.2 Removing from the 7C03 SmartSwitch
The 7F06-02 Module inserted in the 7C03 MMAC SmartSwitch can be
removed upon proper removal of power. Follow the steps below and refer
to Figure 3-3 to remove the module.
Note: Before removing the 7F06-02 module, attach the antistatic wrist
strap included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. As a precaution, power down the MMAC 8 before beginning the
installation or removal of any modules. At the very minimum, the
7C03 must be pulled to disconnect it from the power source. Damage
to modules may result if this procedure is not followed.
2. Use a slotted screwdriver to loosen the two screws that secure the
module to the chassis.
3. Locate the two ejector tabs on the module (to the right of the screws
on the top and bottom of the module).
4. Simultaneously press down on the bottom ejector tab and up on the top
ejector tab until the module ejects from the backplane.
5. Grasp both ejector tabs and carefully slide the module out of the
chassis.
Figure 3-3 Removing the 7F06-02 Module from the 7C03 MMAC
SmartSwitch
CPU
SN
Screw
Ejector Tab
Screw
Ejector Tab