Great Plains 7560 Series VII Field Cultivator-Floating Hitch Parts Manual - Manual (Page 7)

Revision Comments Part Description Part No. Ref.
Image No. 00002 dwg
CENTER FRAME 560-113H 1.
Rev. 2 S/N 1425CC+ CENTER TORQUE TUBE 7000FC 560-300H 2.
Rev. 1 S/N 1424CC- CENTER TORQUE TUBE 7000FC 560-075H 2.
CENTER BRACE BAR 560-109H 3.
CENTER FOLD BRACKET 560-021H 4.
CENTER FOLD BRACKET REAR 560-110H 5.
CENTER WING STOP 560-121H 6.
CYLINDER REST PAD, 3 1/2 560-015H 7.
CYLINDER REST PAD 4 560-208H 8.
PIN HINGE 1 1/4 X 6 HRDN PLT 805-378C 9.
PIN HINGE 1 1/4 X 7 HRDN PLT 805-349C 10.
Rev. 2 HHCS 3/8-16 X 2 1/4 GR8 SP THD 802-623C 11.
Rev. 1 Changed to 802-623C HHCS 3/8-16 X 2 1/2 GR5 802-114C 11.
Rev. 2 NUT HEX TOP LOCK 3/8-16 PLT 803-123C 12.
Rev. 1 Changed to 803-123C NUT LOCK 3/8-16 NYLON INSERT 803-078C 12.
HHCS 3/4-10 X 2 1/2 GR5 802-212C 13.
WASHER LOCK SPRING 3/4 PLT 804-023C 14.
NUT HEX 3/4-10 PLT 803-027C 15.
HHCS 3/4-10 X 2 GR5 802-064C 16.
U-BOLT 5/8-11 X 4 1/32 X 4 1/4 806-179C 17.
WASHER LOCK SPRING 5/8 PLT 804-022C 18.
NUT HEX 5/8-11 PLT 803-021C 19.
WING WHEEL BRKT RH 560-117H 20.
HHCS 1/2-13 X 6 1/2 GR5 802-323C 21.
WASHER LOCK SPRING 1/2 PLT 804-015C 22.
NUT HEX 1/2-13 PLT 803-020C 23.
U-BOLT 1/2-13 X 3 1/32 X 5 806-189C 24.
WHEEL ALIGNMENT STUB 560-133H 25.
U-BOLT 5/8-11 X 2 17/32 X 3 1/2 806-182C 26.
PIN HITCH 1/2 X 4 1/2 W/KEEPER 805-379C 27.
PLASTIC END CAP - 4 X 3 X 1/4 TUBE 817-585C 28.
BUSHING CYL 1 1/4 X 1 X 1 890-005C 29.
12/09/09 - 7 - 560-201P
Table of Contents Part Number Index
Section 2: Frames
Center Frame Assembly
(Applies to 7551FC F H, 7553FC F H, 7556FC F H, 7558FC F H, 7560FC F H only)