Great Plains DVN8324 Predelivery Manual - Manual (Page 12)

550-466Q 11/25/2013
8 8315-8324DVN Great Plains Manufacturing, Inc.
Assembly
Install Center Hub/Wheel
Note: If center hub/wheel assembly is already installed
on machine go to, See “Refer to Figure 6” on
page 8.
Refer to Figure 5
19. While unloading machine from truck, lower Discova-
tor down close to ground leaving high enough to
install center hub/wheel assembly
.
Note: Pin and roll pin will be in manual pak located on
hitch.
20. Locate center hub/wheel assembly , slide spindle
into torque tube .
21. Align holes, attach pin through holes and secure
with roll pin.
22. Repeat same procedure for other side.
23. Remove screw jack from field position on hitch and
install in storage position on front left side of hitch.
24. Now machine may be carefully lowered down to
ground and let machine rest on tires and jack.
Note: Attach machine to tractor as shown in “Operator’s
Manual”, to raise machine up and down for ease of
installing components.
Install K-Flex Shanks
Refer to Figure 6
25. If machine is equipped with magnum shanks, See
“Refer to Figure 7” on page 9.
26. The shank mounts will be shipped in correct location
from factory. If something got moved during shipping,
go to layout section of “Operator’s Manual” for proper
placement.
27. Locate shank assemblies from misc. box and remove
the 5/8 x 2 bolt from shank assembly .
28. Slide shank assembly through slot in shank mount
and align holes as shown below.
29. Re-attach 5/8 x 2 bolt , secure with 5/8 lock nut.
30. Bolt may be tightened to specs, See “Torque Val-
ues Chart” on page 13.
31. Repeat same procedure for rest of shanks.
Figure 5
Center Hub/Wheel
41687
1
2
3
U
D
F
B
L
R
1
1
2
1
3
2
Figure 6
K-Flex Shank
41633
2
1
3
U
D
F
B
L
R
1 2
2
3
1
1