Great Plains 7560 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 26)

Section 1: Assembly
Table of Contents ► Great Plains Mfg., Inc.
Series VII 7551-7560 Field Cultivator, Rigid Hitch 560-199M 2/01/2005
24
Gauge Wheel Assembly
U-bolt the gauge wheel bracket (1) to
the front bar of inside wing brace as shown in
Figure 13 using the 5/8 x 4 x 4 1/4 u-bolts (2),
lock washers and hex nuts. Slide the gauge
wheel arm/hub assembly (3) up into the gauge
wheel bracket (1) and pin with the 3/4 x 4 1/2
pin (4). Use four 1/2 x 1 1/4 hex bolts (5) to
secure the arm and make it rigid. Bolt on the
4-bolt rim and tire (6) with four 1/2 x 1 lug
bolts (7). For directions on the proper setting
for the gauge wheel during operation, refer to
Section 5, page 50.
Figure 13
5/15/2007