Great Plains 7560 Series VII Field Cultivator-Rigid Hitch Operator Manual - Manual (Page 15)

Great Plains Mfg., Inc. Table of Contents ►
Introduction
5/15/2007 Series VII 7551-7560 Field Cultivator, Rigid Hitch 560-199M
13
Assembly and Setup Assistance
If you do not understand any part of this manual
or have other assembly or setup questions, assis-
tance is available. Contact
Product Support
Great Plains Mfg. Inc., Service Department
607 Main Street
Tipton, KS 67485
Pre-Assembly Checklist
• Before assembling, read and understand “Im-
portant Safety Information,” beginning on
page 1.
• Have at least two people on hand while as-
sembling.
• Make sure assembly area is level and free of
obstructions (preferably an open concrete ar-
ea).
• Have all major components.
• Have all fasteners and pins shipped with
Series VII Field Cultivator.
• IMPORTANT: If a pre-assembled part or fas-
tener is temporarily removed, remember
where it goes. Keep the parts separated.
• Have a copy of the parts manual on hand. If
unsure of proper placement or use of any part
or fastener, refer to the parts manual.
•
Check that all working parts are moving free-
ly, bolts are tight, and cotter pins are spread.