Great Plains 1500TM Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Introduction 7
12/12/2013 586-535Q
7. If heavy fork lift or two fork lifts are available the
machine may be lifted off the truck before assem-
bling rest of machine. Double-check that all chains
and tie-down straps have been released and
stowed.
8. Set parking brake on tractor and trailer.
9. Slowly lift the Turbo Max off trailer bed using two
fork lifts.
10. Stop lifting about 12” above the bed.
11. Have the truck driver slowly pull the trailer straight
out from under the Turbo Max.
12. Making sure to keep level from front to back and
side to side, slowly lower the Turbo Max.
13. Slowly lower Turbo Max until it is resting on the
coulter gangs.
Unpacking Boxes
Note: Position boxes in area that you can maneuver
components up to machine to assembly.
14. Carefully remove banding from boxes.
15. Carefully remove banding from brace bars and fin-
ishing reels.
16. Locate and identify all components before assem-
bling.
Assembly and Setup Assistance
To order additional copies of pre-delivery instructions
or operator’s and parts manuals, write to the following
address. Include model numbers in all correspon-
dence.
If you do not understand any part of this manual or
have the assembly or setup questions, assistance is
available. Contact:
Product Support
Great Plains Mfg. Inc., Service Department
PO Box 5060
Salina, KS 67402-5060
(800)255-9215