Completing setup – Great Plains 6324DV Operator Manual User Manual
Page 25
Great Plains Mfg., Inc.
Section 1: Assembly
6/10/2004
Series VII 5110-6324 Discovator 550-220M
23
Completing Setup
Install the plastic end caps into all the
open ends of all the 4x3 frame tubes.
You should now be ready to add
shanks and the remaining gangs to the
machine. If the machine has a finishing
attachment you would install it last. See the
machine layout Section 4 for proper shank and
gang locations for your unit. The parts manual
shows the individual shank assemblies and
parts for both the K-flex and magnum shanks
along with gang parts and identification
drawings.
Once the shanks and gangs are
installed and all of the hydraulic procedures
have been completed, you may fold the
machine to check for clearance and proper
shank placement. Slowly fold the machine
while watching that hoses do not become
pinched or kinked and watch that shanks clear
all obstructions.
Once the machine is folded completely,
begin to unfold slowly. Be Sure No One Is
Under The Wings When You Unfold The
Machine. Once the machine is unfolded, add
the safety decals and the product decals. Refer
to the Important Safety Information (page 7)
for the proper placement of safety decals.
Install the safety chain, SMV sign &
safety lights in accordance with local and state
laws. See parts manual (Section 6: Safety) for
assembly drawings and parts list.
At this point, set up of the machine is
complete and you are ready to add any
finishing attachment, rear hitches, etc… to the
machine. Be sure to consult the operating
instructions, Section 4, for the first time field
adjustments before going to the field for the
first time.
2/02/2005