Great Plains P14222 - Manual (Page 19)

19 Series 5 Toolbar
Operating Instructions
4.7 Overview of Lubricating Points
Fig. 4.02: Wheel Hub Grease Points
Trailing Unit Wheel Pivot and Pivot Bolt 50 Hours 4.01
Trailing Unit Wheel Bearings 50 Hours 4.02
Series 5 Toolbar lubrication points Interval Diag. No.
Servicing and Maintenance
Fig. 4.01: Wheel Pivot Grease Points
4.8 Lubricating the
Machine
Please read the section entitled "Using
Lubricants" carefully before lubricating the
machine.
The machine must be lubricated regularly in
order for it to remain serviceable. Regular
lubrication also contributes towards extending
the service life of your machine.
The recommended lubricating intervals are
specified in "Inspection" and "Maintenance
Intervals".
After it has been washed using a high-
pressure hose or steam cleaned, the machine
should always be lubricated using a grease
gun. Ensure that the universal joints and
splined shafts are lubricated regularly.
4.8.1 Handling of
Lubricants
Please ensure that you read the following
instructions as well as the relevant
information. This also applies to any of your
employees who handle lubricants.
4.8.2 Hygiene
Lubricants do not present a health hazard
provided they are used for their specified
purpose.
In the case of prolonged skin contact,
lubricants - especially low-viscosity oils - may
remove the natural layer of fat contained in
the skin, resulting in dryness and possible
irritation .
It is important to take extreme care when
handling waste oil as it may contain other
irritants.
Vapours given off by cleaning agents and oils
are also a potential health hazard.
You should therefore not carry any oily cloths
around. Change soiled work clothing as soon
as possible.
Always exercise extreme care and observe
the recommended hygiene rules when
handling mineral oil products. Details of these
handling regulations can be found in
information provided by the health authorities.
Б