Great Plains 3P605NT Assembly Instructions - Manual (Page 3)

Great Plains Mfg., Inc.
Installation Instructions 3
09/25/2006 151-125M
Refer to Figure 5.
6. Starting at the Grease Bank, pull one end of the
nylon tubing
➇
from near the panel to the left-most
coulter pivot.
Route the tubing along the inside of the top frame
tube, and through the forward hole in each brace
plate.
Avoid kinks and sharp bends in the tubing. Route it
away from sharp objects and moving parts of the
machine.
Continue to route the tubing down to the fitting adap-
tor
➈
at the left-most coulter pivot.
Figure 5
Tubing Through Brace Plate
Refer to Figure 6.
7. Connect the end of the tube
➇
to the fitting adaptor
➈
at the coulter pivot. Press the tubing into the fitting
until it connects.
8. At Grease Bank plate
➁
, cut the tubing
➇
at the
plate, allowing some slack.
9. Loosen the compression nut of the fitting
➄
lowest
zerk. Do not completely remove the nut, or the com-
pression fitting may rotate out of alignment, or fall out
and be lost. Insert tube into compression fitting and
tighten.
Figure 6
Tubing at Coulter Fitting
Refer to Figure 7.
10. Working from machine left to right, repeat this pro-
cess for each coulter hub.
Note: One hole in the bank plate is unused.
11. When all coulters have been tubed, secure the bun-
dle with the ties
➃
(not shown). Trim excess tie tabs.
Figure 7
Completed Grease Bank plate
25097
➇
25098
➈
➇
25099
➁
➀
➇