beautypg.com

Warning, Seed-lok lock up, Marker adjustments – Great Plains 8030P G1022 Operator Manual User Manual

Page 26

background image

23

Section 3 Adjustments

5/2/07

60303P and 80303P Three-Point Planter 401-008M-A

Great Plains Mfg., Inc.

Offset. The closing wheels can be offset to help prevent
trash from plugging the closing wheels.

To offset the closing wheels:

1.

Raise planter slightly to remove weight from closing
wheels.

2.

Remove 5/8-inch bolt attaching wheel to press-wheel
arm. See Figure 3-15.

3.

Move closing wheel to rear mounting hole and reattach
with 5/8-inch bolt. Torque bolt as recommended on
Torque Values Chart, “Appendix,” page 39.

Figure 3-15

Closing Wheel Offset

If the closing wheels are not offset, mount wheels in the
front holes of press-wheel arm.

Closing Disk Option
For proper seed-to-soil contact, the closing disks must
have enough down pressure to close the seed trench with-
out unnecessary soil compaction.

To adjust down pressure on closing disks, ratchet spring
cam to next cam height by turning head of support bolt (1)
clockwise. Refer to Figure 3-16.

Figure 3-16

Closing Disk and Tube Holes

17893

17890

Seed-Lok Lock Up

Optional Seed-Lok firming wheels provide additional
seed-to-soil contact. The wheels are spring loaded and do
not require adjusting. In some wet and sticky conditions
the wheels may accumulate soil.

To lock up the firming wheels in wet conditions, raise plant-
er. Push lock-up handle (1) on top of row-unit body up into
position shown in Figure 3-17. Push up on firming wheel
(2) until wheel arm latches up.

To unlock firming wheels, turn lock-up handle back to its
90-degree position.

Figure 3-17

Seed-Lok Lock Up

NOTE: Side gauge wheel is removed in Figure 3-17 for
clarity.

Marker Adjustments

!

WARNING!

Pinching and crushing hazard. The moving markers could
pinch or crush bystanders. Never allow anyone near the planter
when cycling the markers. Reduce marker folding speed to a
safe speed.

!

WARNING!

Escaping fluid under pressure can have sufficient force to pene-
trate the skin. Check all hydraulic lines and hoses before apply-
ing pressure. Fluid escaping from a very small hole can be
almost invisible. Use paper or cardboard, not body parts, to
check for suspected leaks. If injured, seek medical assistance
from a doctor that is familiar with this type of injury. Foreign
fluids in the tissue must be surgically removed within a few
hours or gangrene will result.

17810

This manual is related to the following products: