Wheatheart In-Bin Super Sweep - Manual (Page 8)

1. A SSEMBLY W HEATHEART - I N -B IN S UPER S WEEP
1.4. W HEEL M OVE O PTION A LL M ODELS
8 IM5-R1
Figure 1.5 Flighting and Backboard Assembly
5. Adjust collar until pivot assembly holds the first sweep section of flighting
about 1/8” off the floor (this is level).
6. The pivot assembly can be adjusted up to 10” horizontally in four different
positions by means of the two welded pegs and the welded cross pipes,
which can be swiveled 180°.
Note: In severe cases, extra walking shoes can be added to outer sections to prevent
tipping.
1.4. WHEEL MOVE OPTION
1. Assemble on flat surface.
2. Slide the outermost Supersweep backboard over the drivewheel alignment
pin and driveshaft.
3. Insert the hairpin to prevent the backboard from sliding back.
4. Place the backboard locking bracket against backboard and over the
backboard mount bracket.
5. Mark and drill the hole locations for bolting or welding the locking bracket to
the backboard.