Dymo LabelManager 450 User Manual - Manual (Page 14)

15
Troubleshooting
Review the following possible solutions if you encounter a problem while using your labelmaker.
If you still need assistance, contact DYMO Customer Support for your country. Refer to Contacting
Customer Support on the inside back cover to locate the contact number for your country.
Problem/Error Message Solution
No display • Ensure the labelmaker is turned on.
• Replace discharged batteries.
Poor Print Quality • Replace discharged batteries or attach power adapter.
• Ensure tape cassette is installed properly.
• Clean the print head.
• Replace the tape cassette.
Poor Cutter Performance Clean the cutter blade. See Caring for Your Labelmaker .
Printing No action required.
Message disappears when printing is finished.
Too many characters
Exceeded maximum number of characters in buffer. Delete some or all of the buffer text.
Too many lines
Exceeded maximum number of lines allowed. Select another format.
Insert Tape Cassette
Tape cassette missing Insert a new tape cassette
Battery low
Batteries almost discharged. Replace batteries or connect AC power adapter.
Tape Jam
Motor is stalled due to tape jam. • Remove jammed tape and replace tape cassette.
• Clean cutter blade.
Set
Fixed-length label selected and the length
necessary to print the label exceeds the selected
length. • Following this message, a fixed-length value is
displayed which indicates the minimum label length
necessary to fit the text. Do one of the following:
• Adjust the fixed-length label setting appropriately, or
• Select a narrower font size.