Cv1502 cv2502, Cv1502, Cv2502 – Carver CV Series User Manual

Page 6: Power output power output, Common features

Rev 04.08.021

- 6 –

CV1502 CV2502

Power Output

• 150W per channel into 4 ohm and 8 ohm loads,

• 250W per channel into 4 ohm and 8 ohm loads,

autoformer coupled, 40Hz to 20kHz ±3dB

with < 0.5% THD at full power

• 150W per channel, transformer coupled @ 25V,

• 250W per channel, transformer coupled @ 25V,

35V, 50V, 70V and 100V, 40Hz to 18kHz ± 3dB

with < 0.5% THD at full power

• 300W parallel mono at 4 Ohms, 300W parallel

• 500W parallel mono at 4 Ohms, 500W parallel

and bridged mono at 8 and 16 Ohms, 50V, 70V,

100V, 140V and 200V with no more than 0.5% THD

Common Features

• Convection Cooling

• 5-segment LED level display, per channel,

including signal present and clip indicators
• 3 LED display, per channel, of Power, Protect and

Thermal Overload

• Standby LED indicates the amplifier is in Standby

Mode

• Data LED (used with Computer Control module)

• Level controls can be covered with a cap

(supplied) to prevent tampering

• Remote control of output level via Euro Style

connector

• Unbalanced Effects Loop (send/receive) via Euro

Style Connector

• Standard Dual Input Module with line level inputs

via Euro Style connectors and XLR jacks,
connected in parallel

• Switched Clip Limiters

• 26Hz High Pass Filters

• Switched 80Hz and 120Hz (12db/Octave cut)

High Pass Filters
• Terminals for Sequencing Power ON/OFF

• Speaker Outputs via large gauge Euro Style

connectors

• Power Switch, 3 positions On, Off, Standby

• AC Line Cord (Detachable IEC Type)

• Optional Accessories:

− Four Input Mixer Module with zone assignment

− Paging Modules with variable ducking

− Expanded Mic/Line Level Input Module
− Computer Control & Monitoring via

ON Media



Control Module

− DSP control of 28 Band Graphic EQ, 5 Band

Parametric EQ, HP Filter, LP Filter, Crossover,
Adjustable Limiting and Adjustable Delay via

ON Media

 DSP Tools Module