Carver CV Series - Manual (Page 4)

Rev 04.08.021 - 4 –
CV1501 CV2501
Power Output Power Output
• 150W mono into 4 ohm and 8 ohm loads,
• 250W mono into 4 ohm and 8 ohm loads,
autoformer coupled, 40Hz to 20kHz ±3db autoformer coupled 40Hz to 20kHz ±3dB
with < 0.5% THD at full power with < 0.5% THD at full power
• 150W mono transformer coupled @ 25V,
• 250W mono transformer coupled @ 25V,
35V, 50V, 70V and 100V 40Hz to 18kHz ±3dB 35V, 50V, 70V and 100V, 40Hz to 18kHz ±3dB
with < 0.5% THD at full power with < 0.5% THD at full power
Common Features
• Convection Cooling
• 5 segment LED level display per channel
including signal present and clip indicators
• 3 LED display per channel of Power, Protect
and Thermal Overload
• Standby LED indicates the amplifier is in
Standby Mode
• Data LED (used with Computer Control &
Monitoring module)
• Level control can be covered with a snap in
cap (supplied) to prevent tampering
• Remote Control of output level via Euro Style
connector
• Unbalanced Effects Loop (send/receive) via
Euro Style Connector
• Standard Mono Input Module with line level
input via Euro Style connector and XLR jack,
connected in parallel
• Switched Clip Limiter
• 26Hz High Pass Filter
• Switched 80Hz and 120Hz (12db/Octave cut)
High Pass Filters
• Terminals for Sequencing Power ON/OFF
• Speaker Output via large gauge Euro Style
connectors
• Power Switch, 3 positions On, Off, Standby
• AC Line Cord (Detachable IEC Type)
• Optional Accessories:
− Four Input Mixer Module with zone assignment
− Paging Modules with variable ducking
− Expanded Mic/Line Level Input Module
− Computer Control & Monitoring via
i ON
Media  Control Module
− DSP control of 28 Band Graphic EQ, 5 Band
Parametric EQ, HP Filter, LP Filter, Crossover,
Adjustable Limiting and Adjustable Delay via
i ON Media  DSP Tools Module