Lcd d, Isplay, Sing – ClearOne MAX IP Conferencing Phone User Manual
Page 5: Max ip p, Hone, Nswer, Inger, Tandby
2 Technical support: 800.283.5936
Lcd diSpLaY
USing the MaX ip phone
The following paragraphs describe how to use your MAX IP phone.
To Make a Call
Press the
1.
ON/OFF key to activate the phone. You hear a dial tone. (The phone icon and line states appear when the
phone is active (see Figure 3).) The line states are displayed at the far right of the display as “1” for line 1 and “2” for
line 2, with the current line state being represented by the letter “c” for “connected,” “i” for “incoming,” “h” for “hold,”
or “r” for “remote hold” (the line is on hold at the far end).
dial the number as you would on a standard phone. The number appears on the LCd screen.
2.
> Note: You can also predial the number while in standby mode and press the ON/OFF key to connect
the call.
To add a pause to the number you are predialing, press and hold the pound (#) key.
To Answer a Call
Press any key (except “
•
*” key, MUTE, VOLUME UP or VOLUME dOWN).
When there is an incoming call, the phone rings (unless the ringer is turned off) and the phone Leds and
phone icon on the LCd screen flash.
To end a Call
Press the
•
ON/OFF key.
To Turn the ringer On/Off (In standby)
Press and hold the star key (
•
*). A music note with a slash through it (Figure 4) denotes that the ringer has been
turned off.
Figure 2 - MAX IP Parts
Figure 3 - MAX IP Phone Icon
Figure 4 - MAX IP ringer OFF Icon