For more information), Technical support – ClearOne RAV Wired Control User Manual
Page 2
© 2004 ClearOne Communications, Inc. All rights reserved. Information in this document subject to change without notice.
800-153-025 Rev 1.0
ClearOne Communications ~ 1825 Research Way, Salt Lake City, UT 84119 ~ 1-800-945-7730 ~
www.clearone.com
C O N N E C T I N G T H E W I R E D C O N T R O L L E R
I-153-00001-1.0
MIC POD IN
RECORD / PLAYBACK
L
R
L
R
IN
OUT
L +
L -
R +
R -
SPEAKER
IN
OUT
LINE
CAMERA
CONTROL
LAN
RS-232
TELEPHONE
SET
LINE
12VDC 2.5A
+
-
!
ANT
40'/12.2m
MUTE
CONFERENCE
ON/OFF
FLASH
REDIAL
#$%
&'(
)*+
,-.
/01
2345
678
9:;<
*'.2
.+0'
2#75'
/'07
'06'4
&190
72
2*10'$11-
%.'#4
&190
72
81.7/'
RAV 600/900 Wired Controller
1. Connect the wired controller to the mixer’s RS-232 serial port using the sup-
plied RJ-11 to DB-9 adapter.
NOTE: Since the wired controller uses the serial port, you must use the mixer’s USB port in
order to connect your computer to the mixer (see the
RAV 600/900 Quick Start Guide for con-
nection instructions).
2. Using RAV Ware, configure the serial port to a baud rate of 57600 with flow
control OFF (see the
RAV 600/900 User’s Manual
for more information).
NOTE: You can also set flow control to OFF via the controller’s menu system. To do this, press
the MENU button, navigate to the CONFIGURATION screen and press ENTER. Next, navigate
to the WIRED CONTROLLER screen and press ENTER. Finally, select ENABLED and press
ENTER. This turns flow control OFF.
tel
1-800-283-5936
1-801-974-3760
fax
1-801-977-0087
TECHNICAL SUPPORT