ClearOne StreamNet Anthology Media Server - Manual (Page 5)

Chapter 1: Getting Started 2
ABOUT YOUR ANTHOLOGY MEDIA SERVER
Your server has several ports on the back for connecting your audio and networking,
• VGA and DVI video ports for connecting to a television or other display. This can be used to view
playlists, etc.(Can be used as a video input for a MediaLinX.)
• Analog stereo audio output to connect to a receiver, pre-processor or amplifier. (Can be used
as an audio input for a MediaLinX.)
• One S/PDIF connector. (Not currently supported.)
• One Ethernet 10/100/1000Base-T Gigabit Ethernet Local Area Network (LAN) port for media
sources and control system interface.
• Multiple USB ports for storage expansion.
• Front panel power status LED.
• 28V DC Power supply input
• ON/OFF button
VGA DVI
Out USB Ethernet 28V DC Analog
Audio
Out
S/P DIF On/Off
CONNECTIONS
It is important that you make all necessary connections to the ANTHOLOGY media server before
turning it on for the first time.
Certain aspects of the configuration are automatically set the first time you power on the device
based on the connections that are present.
i
NCLuded
a
CCeSSOrieS
The ANTHOLOGY media server includes the following accessories.
• Removable rack mount ears (shipped unmounted)
W
Hat
Y
Ou
N
eed tO
G
et
S
tarted
To setup the ANTHOLOGY media server, you’ll need the following
• A network router or switch connected to the Internet with an available Ethernet port.
• A standard (straight-through) Category 5 or Category 6 Ethernet cable.
• A computer (Windows or Mac) connected to the same network as the ANTHOLOGY media
server.
• 28 V DC Power supply required (PL250 or PL960).