Quoizel CM8412AC Chalmers - Manual

ILLUSTRATION A
CAGE
SOCKET
DOOR
BOLT
BOLT HOLDER
ASSEMBLY / INSTALLATION INSTRUCTIONS
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN! IS-CM8412
Page 1 of 2
Revised 2011-03-14
TAB
GLASS
PANEL
1. Before beginning the installation, carefully unpack and identify all parts referring to
illustration.
2 Turn the electrical power to installation point OFF at circuit breaker
3 Open the DOOR on the CAGE and install the correct bulbs referring to the fixture
markings and or labels for maximum wattage Proceed to close the DOOR by
placing the BOLT onto the BOLT HOLDER
4 Refer to the Illustration B) Please note that the BACKPLATE can be reversed.
Remove the HEX NUTS (small) and WASHERS (small) from the back of the
BACKPLATE. Loose the HEX NUT and the LOCK WASHER. And then push the
BACKPLATE as the arrow and reverse the BACKPLATE up to down. Place the STUDS
back through the holes on the BACKPLATE and then thread the HEX NUTS (small) and
WASHERS (small) back onto the STUDS. Hand tighten until snug. Proceed to tighten
the HEX NUT and LOCK WASHER against the BACKPLATE.
5 Place the CROSSBAR on the BACKPLATE and align the holes in the side of the
BACKPLATE with the threaded holes in the folded edge of CROSSBAR. Next, mount
the CROSSBAR to the outlet box with (2)OUTLET BOX SCREWS (not provided).
6. :
Use wire connectors(not supplied) connect the HOUSE GROUND to the FIXTURE
GROUND WIRE attach the HOUSE WHITE WIRE to FIXTURE WHITE (or RIBBED
SIDE) SUPPLY WIRE; connect the HOUSE BLACK(or RED) WIRE to the FIXTURE
BLACK(or SMOOTH SIDE) WIRE. Wrap each connection with approved electrical
tape.
,
.
/ .
.
.(
.
;
. .
Make the connections
Note If you find any Tabs do not engage Glass Panels well during assembly please
push the Tabs until they are attaching onto the Glass Panels
: ,
.
BACKPLATE
(2)MOUNTING SCREWS
(2)OUTLET BOX SCREWS
(not supplied)
CROSSBAR OUTLET BOX
FIXTURE SUPPLY WIRE
and GROUND WIRE
ILLUSTRATION B
BRACKET
CAGE
HEX NUT and LOCK WASHER
BACKPLATE
(reverse up to down)
HEX NUT
(small)
WASHER
(small)
7. Carefully tuck all wires into the WALL MOUNTED OUTLET
BOX and position the fixture over the outlet box. Align the
HOLES in the side of BACKPLATE with the 2
MOUNTING HOLES on the folded edge of the
CROSSBAR. Secure them by threading 2 MOUNTING
SCREWS into the MOUNTING HOLES on the folded edge.
Tighten until snug.
8.Refer to Page 2 for fixture caulking installations.
9. Restore power to the installation point ON. Retain this
sheet for future reference.
( )
( )