Quoizel TFIK9471VA Inglenook - Manual

1of1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc. July2014
A. Thread Upper Rod, Rods and Base
together. Hand tighten until snug.
B. Pull the cord from the Base as you
assembled the parts together to
remove the excess cord between
parts.
C. Place Shade, Flat Washer and Steel
Collar over Socket. Secure by
threading Socket Collar onto Socket.
Hand tighten until snug.
D. This fixture uses standard bulb with
medium base . Maximum 150 watts.
Insert bulb and screw snugly into
place.
Your fixture is now assembled and
ready to use. Enjoy!
Tools Required: none
Bulb Recommended:
Estimated Assembly Time:
Preparation:
(1) Medium Base 150W Maximum, Alternate bulb (1) 42W CFL
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Assembly Instruction Sheet #IS-TFIK9471VA
For Style TFIK9471VA
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
Bulb
1
16” SQ.
Socket Collar
x 1
Steel
Collar
x 1
Shade
x 1
Socket
Dimmer
Upper Rod
x 1
Rod
Rod
x 2
Base
x 1
Supply Wire
TFIK9471VA
FINISH: VALIANT BRONZE
(1) 150W Medium
Base bulb
(not provided)
PART NUMBER
19471VATFIK
REPLACEMENT PART
BASE
REQ. NO.
1
M1834RG
G2085SH
RETAINER RING
SHADE 3
2
1
1
1
9”
71”
11” SQ.
2
3
Flat Washer
x 1