Quoizel MC1701TWT Mica User Manual
Warnings and cautions

1of1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at
2014 QuoizelInc.
June2014
A. Attach the cover end of the
Center Rod Assembly onto the
Junction Box and secure with
Lock Screws. Hand tighten until
snug.
B. Place the Shade onto the Clip on
the top end of the Center Rod
Assembly. (Refer to Figure 2)
Line up the long spider of the
Shade and the long edge of the
Base during assembly.
C. Place the Rubber Shade, the
Diffuser and the Cap over th top
end of the Center Rod in turn and
secure with the Finial. Hand
tighten until snug.
D. This fixture uses standard bulb
with medium base . Maximum 60
watts. Insert bulb and screw
snugly into place.
Your fixture is now assembled
and ready to use. Enjoy!
Base
MC1701TWT
FINISH: WESTERN BRONZE
PART NUMBER
11701TWTMC
S1628DI
S1560MC
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/2"
REPLACEMENT PART
BASE
DIFFUSER
SHADE
NO.
(2) 60W
Bulbs
(Not Supplied)
Medium
Base
1
2
3
REQ.
1
1
1
Tools Required: Flathead screwdriver, Phillips screwdriver.
Bulb Recommended:
Estimated Assembly Time:
Preparation:
(2) Medium Base 60W Maximum, Alternate bulb (2) 13W CFL
15-20 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Assembly Instruction Sheet #IS-MC1701TWT
For Style MC1701TWT
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Finial
Cap
Diffuser
Rubber Washer
Shade
Clip
Center Rod
Assembly
Lock
Screw
Junction Box
Shade
FIGURE 1
FIGURE 2
Spider
Spider
8.5
”
5
”
14
”
23 5
”
.
8
”
13
”
7.5
”
1
3
2