Step 4, Step 5, Step 6 – Quoizel KD1716MM Kendra User Manual
Page 3: Step 7, Step 8, Installation instructions
3 OF 3
STYLE NUMBER KD1716MM
:
STEP 4:
a Locate Crystals onto the Hangers on the bottom of
Side Arms as shown.
.
Side Arm
Hanger
Crystal
STEP 5:
a Screw the Mounting Screws into the Crossbar
place the Lock Washers over the Mounting Screws
and thread the Hex Nuts onto the Mounting Screws
as shown
Secure the position of the Mounting
Screws by tightening the Hex Nuts against the
Crossbar
b
Secure the Crossbar to the Outlet Box with Outlet
Box Screws
.
,
.
.
.
.
Outlet Box
Crossbar
Mounting Screw
Hex Nut
Outlet Box Screw
Lock Washer
STEP 6
:
*
(
)
.
.
.
(
)
.
(
)
(
).
.
.
Use Wire Connectors not supplied to connect
the wires
a Connect the House Ground Wire to the Fixture
Ground Wire.
b Connect the House White Wire to the Fixture
Supply Wire White or Ribbed Side .
c Connect the House Black or Red Wire to the
Fixture Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the Outlet Box
WHITE WIRE
BLACK OR RED WIRE
(
)
FROM HOUSE
GROUND WIRE
GROUND WIRE
FROM HOUSE
FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE
FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 7
:
a
Carefully tuck all wires into the wall mounted outlet
box and position the fixture over the outlet box.
b
Align the holes in the Ceiling Canopy with the
Mounting Screws attached to the Crossbar.
c
Pass the fixture over the Mounting Screws and
secure by threading Mounting Balls onto end of
screw. Tighten until snug.
.
.
.
Outlet Box
Mounting Screw
Mounting Ball
Ceiling Canopy
STEP 8
:
a. Install correct Bulbs referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.
INSTALLATION INSTRUCTIONS