Quoizel IE1717BN Ibsen - Manual (Page 2)

INSTALLATION INSTRUCTIONS
2 OF 4
STEP 1 :
a Unfold Side Arms at the 120 degree locations.
b. Refer to Figure 1, place Steel Ring over Socket
Cluster as arrow direction. (Refer to Figure
2)Match the holes on the Ring onto the Mounting
Holes on the Side Arms.
c. Using screwdriver, thread Lock Screws into the
Mounting Holes and tighten until snug to secure the
Steel Ring onto Side Arms.
.
STEP 2:
a Screw the Mounting Screws into the Crossbar
place the Lock Washers over the Mounting Screws
and thread the Hex Nuts onto the Mounting Screws
as shown
Secure the position of the Mounting
Screws by tightening the Hex Nuts against the
Crossbar
b Secure the Crossbar to the Outlet Box with Outlet
Box Screws
. ,
.
.
.
.
STYLE NUMBER IE1717BN :
Side Arm
Socket
Cluster
Steel
Ring
Figure 1
Figure 2
Mounting Hole
Lock Screw
Steel Ring
Outlet Box
Crossbar
Mounting Screw
Hex Nut
Outlet Box Screw
Lock Washer
STEP 3 :
* ( )
.
.
.
( )
. ( )
( ).
.
.
Use Wire Connectors not supplied to connect
the wires
a Connect the House Ground Wire to the Fixture
Ground Wire.
b Connect the House White Wire to the Fixture
Supply Wire White or Ribbed Side .
c Connect the House Black or Red Wire to the
Fixture Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the Outlet Box
WHITE WIRE
BLACK OR RED WIRE ( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH