Quoizel UST1505WT Union Station User Manual

Page 2

2of2

Thank you for purchasing a Quoizel product.

Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700

or visit us on-line at www.quoizel.com

2014 QuoizelInc.

May2014

UST1505WT

PART NUMBER

NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2

REPLACEMENT PART DESCRIPTION

REQ.

NO.

FINISH: WESTERN BRONZE

Figure 6

STEP 6

Install Bulb

A. This fixture uses standard bulbs 60W

(supplied) with standard screw base.
Maximum 100 watts. Insert bulb and screw
snugly into place.

Your fixture is now assembled and ready to

use. Enjoy!

Bulb

Mounting Screw

Hex Nut and
Lock Washer

Mounting Ball

Figure 3

against the

and the

mounting balls. If

ceiling

not, adjust the

length of the nipple on the
Crossbar Assembly (AA) by
unscrewing the preassembled
hex nut and lock washer and then
screwing the mounting screws in
or out of the crossbar until the
correct length is achieved. Once
the Ceiling Canopy (A) is secure,
remove the mounting ball and
Ceiling Canopy (A) and proceed
to Step 5.

STEP 4

Wire Connections

A. Use standard wire connectors (not included) to make all wire

connections. (Connectors are not included with fixture.) Strip and
prepare wire ends according to instructions supplied with
connectors.

B. Connect White Supply Wire from the Outlet Box to Ribbed Side Wire

from fixture. Connect Black (or Red) Supply Wire from the Outlet
Box to Smooth Side Wire from Fixture. Connect Ground Wire from
the Outlet Box to Ground Wire from fixture.

C. Twist connectors until wires are tightly joined together.
D. Wrap each connection with approved electrical tape and carefully

stuff all the connected wires into the Outlet Box.

White wire

from supply

Black wire from
supply (or Red)

Ground wire

from supply

Ribbed side wire
from fixture

Smooth side wire
from fixture

Ground wire
from fixture

Figure 4

Mounting
Screw

Mounting Ball

Figure 5

STEP 5

Install Fixture Body

A. Carefully tuck all wires into the

outlet box and position the Ceiling
Canopy (A) over the outlet box.
Align the holes in the Ceiling
Canopy (A) with the mounting
screws, then attach the Ceiling
Canopy (A) using the previously
removed mounting balls. Hand
tighten until snug.

(1) Medium Base

Decorative Filament

60W bulb (provided),

Maximum 100W.

4.5” Dia.

5” Dia.

5.5” Dia.

45.5”

OVERALL HEIGHT

(2) 6” AND (2) 12” RODS

INCLUDED

6”

2”

7.5”