Quoizel PTN232DK Plantation - Manual (Page 6)

Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
6of6
Assembly Instruction Sheet #IS-PTN232DK
For Style PTN232DK
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
2013 QuoizelInc.
STEP 9 Install Bulb -
A. This fixture uses candelabra bulbs with a screw base.
Maximum 60 watts.
B. Insert bulb and screw properly into place.
Your fixture is now assembled and ready to use. Enjoy!
Bulb
Socket
STEP 8 - Make Wire Connections
A. Un-thread the Canopy Lock Ring (G) and slide Canopy Lock
Ring (G) and Ceiling Canopy (E) down the Fixture Chain (H).
B. Push all slack fixture wire through Canopy Chain Loop (F)
into Outlet Box. Trim excess fixture wire leaving a minimum
of 6 inch. Hanging out of the Outlet Box.
C. Use standard wire connectors to make all wire connections.
(Connectors are not included with fixture.) Strip and prepare
wire ends according to instructions supplied with connectors.
D. Connect White Supply Wire from the Outlet Box to Ribbed
Side wire from fixture.
E. Connect Black (or Red) Supply Wire from the Outlet Box to
Smooth Side Wire from fixture.
F. Connect Ground Wire from the Outlet Box to Ground Wire
from fixture.
G. Twist connectors until wires are tightly joined together.
H. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
G. Re-attach the Ceiling Canopy (E) as shown in Step 5.
Canopy Chain Loop
Fixture Chain
Supply Wire and
Ground Wire
Supply Wire
and Ground
Wire from
Outlet Box
Ceiling Canopy
Canopy Lock Ring
Figure 9
White wire from supply
Black wire from supply
(or Red)
Ground wire from supply Ground wire from fixture
April2013
Figure 8
Figure 10
Ribbed Side from fixture
Smooth Side from fixture