Quoizel KY433IB Kyle User Manual

Page 2

2of3

Thank you for purchasing a Quoizel product.

Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700

or visit us on-line at www.quoizel.com

2014 QuoizelInc.

STEP 8 - Install Shade

A. Place the Shade (A) into the Shade Holder.

Your fixture is now assembled and ready to
use. Enjoy!

STEP 5 - Wire Connections

A. Use standard wire connectors (not included) to make all wire

connections. (Connectors are not included with fixture.) Strip and
prepare wire ends according to instructions supplied with
connectors.

B. Connect White Supply Wire from the Outlet Box to Ribbed side Wire

from fixture.

C. Connect Black (or Red) Supply Wire from the Outlet Box to Smooth

side Wire from fixture.

D. Connect Ground Wire from the Outlet Box to Ground Wire from

fixture.

E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and carefully

stuff all the connected wires into the Outlet Box.

White wire

from supply

Ribbed side wire
from fixture

Black wire from
supply (or Red)

Smooth side wire
from fixture

Ground wire

from supply

Ground wire
from fixture

Figure 5

Shade
Holder

STEP 7 - Install Bulb

A. This fixture uses standard bulb with medium

base. Maximum 100 watts.

B. Insert bulb and screw snugly into place.

Bulb

Figure 8

Figure 7

Crossbar

Button
Stop

Lanyard

Slot

Figure 4

STEP 4 - Attach Lanyard

A. The purpose of the lanyard is to provide the installer a means to

support the fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang from the junction
box and your hands are free to make the wire connections.

B. Turn the Button Stop so it may be inserted into the Inner Backplate

slot. Make sure the Button Stop is completely inside the Inner
Backplate. Slowly release the fixture to make sure it is supported by
the Button Stop. Proceed to the wiring steps in the next step. Once
you are complete with the wiring there is nothing to do with Lanyard.
The Lanyard will push into the junction box when the fixture is
placed for final mounting.

STEP 6

Install Ceiling Canopy to Crossbar

A. Attach the Ceiling Canopy (HH) over the end of the Nipple (DD) and

secure with the Hex Nut (CC). Hand tighten until snug.

B. Thread the Finial (EE) onto the Nipple (DD) and hand tighten until

snug.

Figure 6

August2014