Quoizel TFIK348VA Inglenook - Manual

OUTLET BOX
HOUSE SUPPLY and
GROUND WIRES
OUTLET BOX SCREWS
not supplied ( )
CROSSBAR
SHAKE PROOF
WASHER A
LOCK NUT A
NIPPLE
LOCK NUT B
SHAKE PROOF
WASHER B FIXTURE SUPPLY
and GROUND WIRE
CEILING CANOPY
QUICK LINK
QUICK LINK
KNOB
FIXTURE CHAIN
SMALL LOOP
FIXTURE LOOP
SHADE
MAIN ASSEMBLY
SOCKET
SMALL LOOP
BAR
LOCK BALL
SHADE
LOCK SCREW
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
FIGURE2
FIGURE1
1. Before
2.
, ,
.
.(
.
beginning the installation carefully unpack and identify all parts referring to the illustration.
Turn power to the installation point OFF at circuit breaker
3 Refer to FIGURE1) Locate MAIN ASSEMBLY inside of SHADE and match the holes on BARS with holes on the
top edge of SHADE. Place the LOCK SCREWS through the holes on the BARS and SHADE from the bottom up.
Hand LOCK BALLS onto the LOCK SCREWS and hand tighten until snug to secure MAIN ASSEMBLY and SHADE
together.
4
Fasten the CROSSBAR to the OUTLET BOX with (2) OUTLET BOX SCREWS(not supplied).
Proceed to thread LOCK NUT A and SHAKE PROOF WASHER A onto the top end of NIPPLE. Thread NIPPLE
into the center of CROSSBAR. Locate the LOCK NUT B onto the bottom end of the NIPPLE. Tighten LOCK
NUT A against CROSSBAR with pliers until snug.
5 Locate FIXTURE CHAIN and determine desired hanging height of fixture Adjust chain by removing links
if needed Proceed to attach the QUICK LINKS on the end of FIXTURE CHAINS onto FIXTURE LOOPS and
SMALL LOOPS. Pass supply wire through one FIXTURE CHAIN alternating links and pass the supply wire
through CEILING CANOPY
FOR CANADIAN INSTALLATION-PLEASE REFER TO PAGE 2:
(Refer to FIGURE1)
. .
.
.
ASSEMBLY / INSTALLATION INSTRUCTIONS
6.
Using
wire connectors (not supplied)connect the HOUSE GROUND WIRE to
the FIXTURE GROUND WIRE
connect the HOUSE WHITE WIRE to
the FIXTURE SUPPLY WIRE (WHITE or RIBBED SIDE); connect the
HOUSE BLACK (or RED) WIRE to the FIXTURE SUPPLY WIRE (BLACK
or SMOOTH SIDE). Wrap each connection with approved electrical tape.
7. With the proper connections made, proceed to thread the LOCK NUT
B and SHAKE PROOF WASHER B onto the bottom of the NIPPLE.
Lift CEILING CANOPY upward and make the center hole over the
end of NIPPLE
Be sure that all wires are carefully tucked into
OUTLET BOX cavity Secure by threading KNOB onto end of
NIPPLE and hand tighten until snug
8. Install bulbs referring to fixture markings and or labels for maximum
wattage
9. Restore power to the installation point ON Retain this sheet for
future reference
MAKING THE WIRING CONNECTIONS:
(Quoizel recommends (2) people for the next 2 installations)
;
.
.
.
/
.
.
.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
IS TFIK348
Page 1 of 3
2006 8-17 -
-