Quoizel ZE2816K Zen - Manual (Page 3)

INSTALLATION INSTRUCTIONS
3 OF 3
STEP 4 :
* ( ) .
.
.
( )
. ( )
( ).
.
.
Use Wire Connectors not supplied to connect the wires
a Connect the House Ground Wire to the Fixture Ground
Wire.
b Connect the House White Wire to the Fixture Supply Wire
White or Ribbed Side .
c Connect the House Black or Red Wire to the Fixture
Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the Outlet
Box
WHITE WIRE
BLACK OR RED WIRE ( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 5:
a Place the Ceiling Canopy over the Mounting Screws and
thread Mounting Balls onto the Mounting Screws to secure
it. Hand tighten until snug.
.
STEP 6:
(Refer to Fig.1)
a. Thread the beaded end of the Stem into the Coupling
underside of the Socket Cluster. Hand tighten until snug.
b. Pass the Diffuser, the Rubber Washer and the Flat Washer
over the end of the Stem in turn and secure with the Hex
Nut (1/8IP). Hand tighten gently until snug.
c. Thread the Finial onto the end of the stem and hand tighten
until snug.
(Refer to Fig.2)
d. Please make sure the Diffuser is under the Tabs in the
bottom of the Shade after Assembly.
Outlet Box
Mounting Screw
Ceiling Canopy
Mounting Ball
Stem
Flat Washer
Hex Nut (1/8IP)
Finial
Rubber Washer
Shade Assembly
Socket
Cluster
STEP 7
.
:
a Install correct Bulbs referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.
Coupling
Diffuser
STYLE NUMBER ZE2816K :
Fig.2
Fig.1
Diffuser
Shade
Tab