Quoizel TF885CVB Stephen - Manual (Page 3)

INSTALLATION INSTRUCTIONS
3 OF 3
STEP 4 :
a Adjust the Fixture Chain to your desired length by
removing the links if needed
Please note that depends on chain material thickness
you might be required to use chain pliers to spread links
open
b Pull the supply wires through the Fixture Chain alternating
links And then pull the wires through the following
components in turn
Canopy Lock Ring Ceiling Canopy Canopy Chain Loop,
Lock Washer and Nipple
c Place Lock Washer over the end of the Nipple and thread
the Canopy Chain Loop onto the end of the Nipple
d Using plier thread the Hex Nut against the Canopy Chain
Loop and tighten until snug
e Attach one end of the Fixture Chain onto the Fixture Loop
and attach the another end of the chain onto the Canopy
Chain Loop
f Refer to Step 5 Wire Connections to connect wires
g Push the Ceiling Canopy upward over the Outlet Box
h Thread the Canopy Lock Ring onto the Canopy Chain Loop
and tighten until snug to secure the Ceiling Canopy
.
.
* ,
.
.
.
:
, ,
, .
.
.
. ,
.
.
.
. - .
. .
.
.
Nipple
Lock Washer
Canopy Chain Loop
Ceiling
Canopy
Fixture Chain
Canopy Lock Ring
Hex Nut
Fixture Loop
STYLE NUMBER TF885CVB :
WHITE OR RIBBED
BLACK OR RED WIRE ( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 5
:
* ( )
.
.
. ( )
( )
. ( )
( ).
.
.
Use Wire Connectors not supplied to connect the
wires
a Connect the House Ground Wire to the Fixture Ground
Wire.
b Connect the House White or Ribbed Wire to the
Fixture Supply Wire White or Ribbed Side .
c Connect the House Black or Red Wire to the Fixture
Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the Outlet
Box
STEP 6:
. a Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.