Quoizel GRT5103IS Grant - Manual (Page 2)

2of3
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc. February2014
Figure 3
AA
BB
CC
DD
CC
BB
EE
FF
Step A
Step B
is about 0.375 ” above the Crossbar (AA).
C. Remove the Canopy Lock Ring (FF) from the Canopy Chain Loop
(EE). Place the Ceiling Canopy (HH) over the Canopy Chain Loop
(EE) against the ceiling to determine the correct position of the
Nipple (DD). Thread the Canopy Lock Ring onto the Canopy Chain
Loop (EE). Adjust the Nipple (DD) to allow the Ceiling Canopy (HH)
to rest against the ceiling when held in place by the Canopy Lock
Ring (FF).
D. Remove the Canopy Lock Ring (FF) and the Ceiling Canopy (HH).
Tighten the Hex Nut (CC) against the Crossbar (AA) to secure in
place.
HH
STEP 4 - Install Fixture Chain and Ceiling Canopy
A. With the Quick Link (GG) not attached to the Fixture Loop (A) and
the Canopy Chain Loop (EE), pull the supply wires through the
Canopy Lock Ring (FF), the Ceiling Canopy (HH) and the Quick Link
(GG) in order.
B. Connect the Fixture Loop (A) to the Canopy Chain Loop (EE) with
the Quick Link (GG).
C. Feed the Supply Wires and Ground Wire through the Canopy Chain
Loop (EE) and Nipple (DD) into the Outlet Box. Cut the wires leaving
approximately 8
” of wire extending from the Outlet Box.
D. Refer to Step 5 for wire connections.
F. Raise the Ceiling Canopy (HH) and Canopy Lock Ring (FF) up the
Quick Link (GG) and over the Canopy Chain Loop (EE). Tighten the
Canopy Lock Ring (FF) onto the Canopy Chain Loop (EE) until tight.
DD
GG
Supply Wires
and Ground Wire
EE
HH
A
FF
Figure 4
STEP 5 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Strip and
prepare wire ends according to instructions supplied with
connectors.
B. Connect White Supply Wire from the Outlet Box to Ribbed side Wire
from fixture.
C. Connect Black (or Red) Supply Wire from the Outlet Box to Smooth
side Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground Wire from
fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from supply
Ribbed side wire
from fixture
Black wire from
supply (or Red) Smooth side wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 5
STEP 6 - Install Shade
A. Attach the Ring (D) to the Shade (E).
B. Place the Shade (E) with the Ring (D)
over the Socket and secure with the
Socket Collar (F). Hand tighten until
snug.
D
E
F Figure 6
STEP 7 - Install Bulb
A. This fixture uses standard bulb with
medium base. Maximum 100 watts.
B. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready
to use. Enjoy!
Figure 7
Bulb
Socket