SCANTECH ID (Champtek company) VEGA V-1040 - Manual (Page 9)

7
power supply if applicable. Press the RED trigger
button at the top side of the unit; aim the bar code,
which covered by the LED red light zone. You will
hear a beep and the green LED indicator will light on
after scan successfully.
2.3 Start up with Bluetooth
Connect the communication cable provided to your
POS or Host system and cradle. Power-on the cradle
with the provided power supply, scan the Bluetooth
MAC address code located on the top side of the
cradle. After approximately five seconds your
connection is operational and the blue led on the
cradle is on.
Before you can use the VEGA with Bluetooth the
scanner must charged for a minimum of 8 hours in
first time, if the battery is full, the charge red light will
be off and green light will be on.
2.4 User’s Installation and Programming Manual
If you need more in depth information about the
VEGA or more advanced setup options you can
download the VEGA User’s Installation and
Configuration Manual on web site:
www.champtek.com