SCANTECH ID (Champtek company) VEGA V-1040 - Manual (Page 10)

3. Programming Sequence
You can set-up your VEGA by scan necessary
programming codes for parameters that meet
applications. After these scan(s) the VEGA is
automatically configured.
The chapters 4 to 9 provide you with the programming
codes necessary for a basic setup. For more
advanced setup options see VEGA user’s manual.
3.1 Factory Default Settings
The default RS232 settings are 57600 baud, 8 data
bits, and no parity.
The factory default settings are shown with <> and
bold in the following pages.
By scanning “Set factory default” code, the setting will
go back to the factory default setting. If you are using
a USB interface, your device will be lost USB interface
settings, please re-configure USB parameter.
Set factory default