Weller WTL1000S User Manual
Model wtl1000s electronic soldering station

OPERATING INSTRUCTIONS
Unpack unit carefully. Place spring and funnel in slot in top of tool stand. Attach tool stand to either side of
power unit, if desired. Fill reservoir with water and wet sponge, distilled water is preferred. Insert tool in holder
and connect tool plug to receptacle on power unit; rotate plug housing to lock plug in receptacle. Insert line cord
plug into properly grounded AC receptacle and turn station on. If the desired temperature key is not installed,
the key may be changed while power is on. Wait 30 seconds. Remove tool from holder and tin tip with solder.
Unit is now ready for use.
Always use the lowest temperature that will handle the load you are soldering. The Weller
®
electronic control
provides maximum power to the heated load even when set to the lowest temperature; therefore, there is no
need to use high temperature to handle heavy soldering loads. By using lower temperatures and properly
selecting tip styles, sensitive components will be protected from heat damage.
A WCM1 Calibration Unit is available that interfaces directly with the WTL1000Ss microprocessor through the
iron receptacle and provides the ability to enable a timed setback mode, a temperature lock out feature, digital
calibration of the unit to an outside temperature reference, and reset the unit to its original factory calibration.
When the unit enters Setback mode, turn the unit off and back on to return to normal operation.
WARNING: This product, when used for soldering and similar applications, produces chemicals known to the
State of California to cause cancer and birth defects or other reproductive harm.
MODEL WTL1000S ELECTRONIC SOLDERING STATION
WARNING:
Do not remove ground prong from line cord plug. Removal may cause tip temperature
control to be erractic.
AVAILABLE MODELS AND HAND PIECES
PRODUCT
DESCRIPTION
WTL1000S-0
Power unit only, 120V 60 Hz, °F dial markings
WTL1000S-0D
Power unit only, 240V 50/60 Hz, °C dial markings
WTL1000S-1
Power unit, 120V 60Hz, °F dial markings, EC1201A tool with ETA tip and tool stand
WTL1000S-1D
Power unit, 240V 50/60Hz, °C dial markings, EC1201A tool with ETA tip and tool stand
WTL1000S-2
Power unit, 120V 60Hz, °F dial markings, EC1302B tool with EPH101 tip and tool stand
WTL1000S-2D
Power unit, 240V 50/60Hz, °C dial markings, EC1302B tool with EPH101 tip and tool stand
WTL1000S-3
Power unit, 120V 60Hz, °F dial markings, EC1503B tool with EMA tip and tool stand
WTL1000S-3D
Power unit, 240V 50/60Hz, °C dial markings, EC1503B tool with EMA tip and tool stand
EC1201A
40 Watt soldering tool w/ETA tip
EC1302B
20 Watt soldering tool w/EPH101 tip
EC1503B
42 Watt high capacity soldering tool w/EMA tip