Waring WFP16S User Manual

Page 10

• Reassemble unit, and run first with the bowl empty, then put

food into the bowl and try again.

Unit jams or vibrates excessively

• Turn unit off and unplug.
• Disassemble the batch bowl/accessories.
• Make sure there is no food in S-blade hub (if applicable).
• Clean food off accessory discs (if applicable).
• Reassemble unit, and run first with the bowl empty, then put

food into the bowl and try again.

Unit will not come up to full speed

• Bowl is overloaded – remove food being processed and reload

using smaller quantities.

If unit does not operate after you have followed the

above

• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown if there are fuses on this

circuit.

• Call local Waring service agency.

If food processor makes grinding noise

• Turn unit off, unplug, disassemble, check bowl and blade to

see if they have been rubbing together.

• If bowl and blade are rubbing, call your authorized Waring

service agency.

CLEANING AND MAINTENANCE

Clean the food processor and accessories prior to initial use and

after each use. Do not use harsh abrasive-type cleaners on any

part of the food processor. Cleaning must follow ETL sanitation

guidelines.
Wash the motor shaft with a small brush.
Wash, rinse, sanitize and dry the bowl, cover, small food pusher,

vegetables vertically, or standing up. For a very fine chop of

onions, quarter the onion and gravity-feed it through the chute.

Removing processed food from the batch bowl

1. Turn the machine off and wait for the blade to stop moving

before removing the lid and pusher.

2. If the blade holds the bowl locked when the motor stops,

move the handle of the bowl rapidly back and forth – first

clockwise, then counterclockwise.

3. If using a disc, remove before tilting the bowl, using a

spatula to scrape off any food sticking to it. If using S-blade,

it will stay locked in the bowl when you tilt to pour. Use

spatula to scrape food out of bowl.

NEVER USE FINGERS

TO REMOVE FOOD WHILE BLADE IS IN BOWL.

TROUBLESHOOTING

This section describes potential problems and the correct

solutions for them. Problems that cannot be solved with the

guidelines listed below should be referred to one of the Waring

Authorized Service Centers for assistance. A listing of authorized

service agencies is supplied with each Waring food processor.

Unit does not start when assembled correctly

• Pull the plug and try plugging into another outlet.
• Press ON Button.
• Make sure the bowl is properly positioned on the motor base,

that the bowl cover is attached properly, and that the safety

interlock tab on the cover has properly engaged the safety

interlock switch.

Unit stops running during processing

• The unit may have overheated. Refer to Resetting Thermal

Protection section (page 13).

• Turn unit off and unplug.
• Remove bowl attachment.
• Remove food being processed from inside the bowl and

discard.

• Allow unit to cool for 30 minutes.