VICI D-4-I Instruction Manual - Manual (Page 18)

16
Electrical Connections
CAUTION: Do not use a wrench to tighten the SMC
connectors on the bias and electrometer cables.
Connections should be finger tight only.
1. Referring to Figure 4 as necessary, connect BIAS-B cable to the top
electrode and the electrometer cable (ELECT) to the bottom electrode.
The BIAS-A remains disconnected.
2. Connect the high-voltage cable from the detector to the pulse supply, and
connect the pulse supply cable between the back of the controller and the
pulse supply. Connect the heater cable from the detector to the back of
the controller.
CONTROLLER
(Rear panel)
HEATER CABLE
FROM DETECTOR
PULSER
MODULE
HIGH
VOLTAGE
ELECTROMETER
BIAS-A
BIAS-B
RED
BLACK
WHITE
GREEN
BROWN
BLUE
ORANGE
YELLOW
RED
BLACK
GREEN
WHITE
0 - 10 V
Common
0 - 1 V
Shield
COM
SET
UNATTENUATED
OUTPUT
AUTO
ZERO
TO COMPUTER
OR INTEGRATOR
+
– ATTENUATED
OUTPUT
SHIELD
TO
RECORDER
(no connection)
Figure 4: Electrical connections
Installation