Valco Baby Twin Tri Mode - Manual (Page 9)

Using your brakes
1. Remove the plugs from the nylon
housing at either side of the stroller
frame by pressing each inner “release
button” and pulling the plug upward.
NOTE: DO NOT remove the plugs in the
centre between both seats. Be sure to
store the removed plugs in a secure place
as they MUST be used whenever nothing
is engaged in the front bar housing to
prevent finger entrapment.
2. Insert the bar ends into the nylon
housing located on either side of the
frame. Be sure that the red buttons
are facing towards the seat and that
the bar is securely engaged.
3. Adjust the front bar by simultaneously
pressing the two red buttons and
swivelling the bar (forward or
backward) to the desired position.
4. Insert the bar ends into the nylon
housing located on either side of
the frame. Be sure that the red
buttons are facing towards the
seat and that the bar is securely
engaged.
5. Adjust the front bar by
simultaneously pressing the two
red buttons and swivelling the bar
(forward or backward) to the
desired position.
IMPORTANT WARNING: The front bar IS NOT a carrying or restraining
device.
TO ENGAGE:
1. Press down on the centre pedal until
the brake pins engage in the nylon brake
cogs in the wheel hub.
IMPORTANT: Always check that the brake
has engaged before use, if not you may
need to move the stroller forward or back
slightly until it locks into place.
2. To disengage, lift the centre pedal
upward till it locks in the upright
position.
Installing/Removing your front bar