Valco Baby Twin Tri Mode - Manual (Page 4)

Remove the stroller from the carton and dispose of all packaging immediately including the
black rubber protectors on either side of the brake bar and front wheel protector. The front
wheel forks, rear wheels, front bar, and hood all need to be installed prior to use.
Stroller Assembly
1. Take the rear axle with the longer
part of the centre pedal facing to
the rear.
2. Identify the locking pins (A)
located on both rear frame legs.
3. Align the locking pins (A) with the
corresponding notches in the
brake housing (B).
4. Push brake housing upwards on
frame leg until pins (A) lock into
the housing (B).
5. Pull on the entire axle to test
that it is securely locked into
place.
Installing/Removing the rear axle-brake system
Lay the stroller flat on the floor and
carefully cut the cable tie which holds
the frame.
To unfold the chassis, locate the rear
legs.
NOTE: The rear centre leg is
highlighted in red.
Opening the stroller chassis
6. Should you need to remove the
brake system for long-term
storage, release each brake
housing by pressing on the pin
release flap (C) and
simultaneously pushing the
housing downwards.