Valco Baby Twin Tri Mode - Manual (Page 6)

Installing/Removing and using the front wheel forks
Pressing the axle button, insert the
protruding long axle into the opening in
the axle tube. (Refer to ‘Using your
brakes’)
NOTE: Ensure that the brake pedal is fully
retracted, so that the brake pin
(highlighted in red) does not obstruct the
wheel cog from fully engaging the housing.
Repeat the procedure for the other side.
TEST that each wheel is securely engaged
by pulling on it.
To remove the wheel, simply press the
axle button in the centre of the wheel hub
and simultaneously pull the wheel
outward.
If your brakes do not engage, check to see
the nylon brake cogs are on the INSIDE of
each wheel when it is attached to the
chassis. If not, remove the wheel and SQR
axle and re-insert the SQR axle from the
other side of the wheel, so that the cog will
be on the inside of the wheel.
Your Twin Runabout stroller utilises our
unique and revolutionary new DUAL TRI-
MODE™ front swivel system:
1. Tilt the stroller frame upward so that
it rests on the handle and the rear
wheels.
2. Insert each fork shaft respectively into
each TRI-MODE housing till it “clicks”
into place.
IMPORTANT: Before use, always test that
the fork is securely engaged in the
housing by pulling on it.
To remove the front fork:
1. Rotate the TRI-MODE selection
dial to the centre (45°) position.
2. Tilt the stroller frame upward so
that it rests on the handle and
the rear wheels.
3. Press the centre release button
and pull the fork away from the
mechanism.