Valco Baby Zee User Manual
Page 4
H
FIGURE H - BUMPER BAR
19. Insert the front bar ends into the nylon housings
located on either side of the frame. Be sure that
the bar is securely engaged.
20. Adjust the front bar by simultaneously pressing
the button on the bar housing and swivelling the
bar to the uppermost position.
21. This is the only position for use with a child in
the stroller.
22. To remove the front bar: Feeling the side of the
nylon housing that sits below the frame at each
side (facing inward), locate the release button.
23. Press each release button inward while
simultaneously pulling upward on the bar housing.
Repeat for the other side. Note that this may be
difficult to do as the bar is secured firmly as a
safety precaution.
IMPORTANT WARNING: THE FRONT BAR IS NEITHER A
RESTRAINING NOR CARRYING DEVICE.
FIGURE I - SEAT RECLINE
Our system offers an almost infinite amount of
individual seat adjustments.
24. TO RECLINE: While squeezing the centre release
mechanism in a pincer action, ease the seat down
to the desired position.
25. TO INCLINE: Place your hand at the centre of the
rear of the seat. Pull the incline strap while gently
pushing on the rear of the seat until the desired
position has been reached.
FIGURE K- ADJUSTING YOUR FOOTREST
26.To adjust your foot rest downward, press the
central buttons on either side of the footrest while
simultaneously adjusting it up or down.
YOUR FOOTREST IS DESIGNED TO COLLAPSE IF EXCESS
WEIGHT IS APPLIED TO IT
FIGURE Q
The Expanda hood unzips, increasing the size of
your standard hood to give greater coverage and
protection from the sun and weather for your child.
To open the Expanda Hood:
27. Locate the zip in the center of the Expanda
Hood and unzip completely
28. Gently pull the Expanda Hood forward until it
is reaches its full extension.
To close the Expanda Hood:
29. Gently push the Expanda Hood back,
allowing the middle section to fold in on itself.
30. Carefully zip the Expanda Hood closed.
31. The hood offers two height positions to allow
for your child’s growth. To increase the height
of the hood simply move the hood to the second
fixture.
PRESS
PULL
I
click
K
L
▲
!
Fixture 1
Fixture 2
31