Valco Baby Zee User Manual
Page 3
FIGURE D - ATTACHING THE BASKET
7. Align the basket frame with the open tubes at
the rear of the seat. Simultaneously pressing in
the locking buttons, slide the basket frame into
the housing until the buttons lock into place.
IMPORTANT: When basket is locked into place - the
locking buttons (pins) will pop through the holes.
(Otherwise it is not securely engaged.)
8. Basket front - pass the front flap over
the bar between the seat and the
seat frame. Secure with the snaps.
Pull the side flaps around the front
and Velcro into place on the front flap.
FIGURE E- INSERTING REAR
WHEELS
9. Simultaneously press on the spring loaded axle
button and insert it through the central hub of the
rear wheel. Repeat this process for the other rear
wheel.
10. Pressing the axle button again, insert the axle
end into the side of the brake housing as far as it
will go. Release the axle button and pull slightly on
the wheel to ensure that it has securely engaged.
FIGURE F - FRONT WHEELS
11. Grasping the front wheel, align the shaft with the
hole in the underside of the swivel housing.
12. Depress the button on the top of the swivel
housing. Insert the shaft into the housing as far as
it can go until it engages securely.
13. Repeat the procedure for the other front wheel.
IMPORTANT: PULL THE WHEEL DOWNWARD TO TEST THAT IT
HAS SECURELY ENGAGED IN THE HOUSING.
LOCKING YOUR WHEELS
14. Your front wheels can be set to swivel freely
(360º) or can be fixed in place for use over rough
or sandy surfaces.
15. To fix the front wheel in the non swivel position,
turn the wheel so that the two notches on both
housings line up. Press down firmly on the swivel
lock until it locks into place.
16. To unlock simply lift the locking tab until it locks
in the open position.
FIGURE G - USING YOUR BRAKE SYSTEM
17. To engage the brake press down on the central
brake pedal, until the brakes engage fully into the
wheel cogs.
18. To disengage, simply reverse the process.
E
F
G
D
10
9
ATTACH
LOCK