Valco Baby Zee - Manual (Page 2)

ASSEmbly
FIGURE A - CONTENTS
1. Remove the stroller from the carton and
dispose of all packaging thoughtfully. Check
contents.
FIGURE B - OPENING
2. Release frame lock on side of stroller frame.
3. Lift the stroller handle upward over 180°
until it locks into a straight line.
4. With one hand holding the lower legs down,
lift the handle vertically until the lower
chassis locks into position. (You should hear
an audible ‘click’).
IMPORTANT WARNING:
ALWAYS TEST THAT ALL LATCHES ARE SECURELY ENGAGED
BEFORE USE.
FIGURE C - INSERTING REAR AXLE
5. Align the plastic housings of the rear brake
section with the open tubes of the rear of the
stroller chassis.
IMPORTANT: BE SURE THAT THE BRAKE LEVER IS UPRIGHT
6. Insert the housings over the open tubes until
the brake section locks securely into place.
IMPORTANT WARNING:
TEST THAT THE BRAKE SECTION IS SECURELY ENGAGED
ONTO THE STROLLER FRAME BY PULLING ON IT FIRMLY.
A
B
C
▲ !
▲ !
▲ !
▲ !
3
4
2
HOOD
BASKET
2 x FRONT WHEELS 2 x REAR WHEELS
BRAKE
SEAT
2 x AXELS
BUMPER BAR