Valco Baby Matrix - Manual (Page 3)

INSERT REAR WHEELS
FIGURE D
10. Depressing the button in the centre hub
in the rear wheel, insert each wheel axle
in turn, into the wheel hub. Push the
wheel as far as it will go before releasing
the button. IMPORTANT: Pull each wheel
slightly back towards you to ensure that
it has fully engaged in the axle.
INSTALLING THE FRONT
WHEEL
FIGURE E
11. Tip the stroller upward on its rear wheels
with the front fork facing to you.
12. Line up the front wheel inside the front
fork making sure that each anchor
washer will be located on the outside of
either side of the fork.
13. Lift the wheel so that the axle engages
in each track at either side of the fork.
14. Gently turn each anchor washer so that
the tab rests inside the securing hole in
the fork.
15. Evenly tighten both sides of the axle so
that the wheel rests equally in the centre
of the fork.
INSTALL THE HOOd
FIGURE F
16. With a screwdriver, remove the screws
and protective covers from the tube.
17. Insert the hood tube end into each
corresponding holding tube and secure
each side with the screw.
D
E
F
PRESS
10
12
14
15
17
Fasten hood to
skirt with the
Velcro strips
found on the
hood and skirt