Unitec WashPay Gen 1 to Gen 2 Upgrade - Manual (Page 10)

W A S H P A Y
Document Number: WP1011 6
3.3 Install the New Site server
Figure 5. Sierra Site Controller
Shut down the WashPay site controller. Disconnect the power, monitor, keyboard, mouse and
network cable from the old server. Setup the new Sierra site controller by connecting the power,
monitor, keyboard, mouse and network cable. When connected, power on the server and monitor.
The server will boot to the login screen.
3.4 Configure the New Site server
Login to the server using the default user ID and password (00 and 00). Select the Set-up menu and
program the site parameters, products and all required device profiles. Programming procedures can
be found in the Sierra Management Application Programming Manual, as mentioned in Section 1.
3.5 Activating Paynode Devices
When the paynodes and printers are powered on, they will automatically connect to the site server but
will require a configuration file (or profile) to be downloaded from the server. The recommended
procedure for activating these devices follows.
1. Apply power to one of the connected devices in the order you would like to arrange the
bays (leaving all others powered off).
2. Select the Set-up then Devices menu options of the Sierra management application. A
table listing connected devices should be displayed. The device which was powered on
should be the only one displayed. (If no devices are displayed, refresh the page to show
the connected device).
3. Select the Edit button next to the paynode and enter the desired name (Bay 1, for
example). Select the desired configuration profile for this paynode and click the save
button to return to the device list.
Document Name: WashPay Gen 1 to WashPay Gen 2 Upgrade Instructions