Unitec Wash Select II to WashPay Integration Installation Manual - Manual (Page 14)

W A S H S E L E C T I I T O W A S H P A Y
Document Number: WS21046 10
Document Name: WSII to WashPayIntegration Field Retrofit Installation Guide
to implement the changes. The device profile configuration file includes a series of set-up
pages, which are described in the following sections.
General Information
The Edit Profile Information page is used to program some general operational settings
of the WashPay system including:
• Initial Price
• Initial Swipe Amount
• Additional Swipe Amount
• Credit Drive Off Limit
Product Dispensing
The product dispensing page is used to assign the timer operational mode, and set the
turn on delay and grace times. The self-serve product must be set-up through the
Products page before it can be assigned to a device profile. This feature will typically
not be changed after installation.
Equipment Interface
The Equipment Interface Set-up page is used to configure the interface between the card
terminal and existing coin box and the pulses per coin or bill. These settings should only
be changed by your distributor.
User Interface Set-up
The User Interface set-up page is used to change messages displayed to customers and
adjust ‘time-warning times for certain timer modes. This page is also used to customize
the text on the screens, that an operator may wish to adjust including the welcome
message, thank you message, and stop button message.
5.2.4 Receipt Printer Setup
The receipt printer setup only requires a paynode name and header and footer text. The
site operator may change the receipt message text at any time.