Cabletron Systems NBR-420 - Manual (Page 48)

Using the LCD
NBR-SERIES Installation Guide Page 4-7
4.3.1 Unsaved Initialization Messages
Unsaved Initialization messages are generated during power-up and
appear as the event occurs. These messages track the boot up sequence.
They are not saved and cannot be recalled.
4.3.2 Static System Messages
Static System messages provide NBR configuration information. The
product name must be displayed on the LCD before you can start stepping
through the messages in the sequence shown in this section.
To Display the Messages
With the product name displayed, momentarily press the DISPLAY
button to step to the first message. Each time you press the DISPLAY
button, the next message is displayed until the last message. Then the
display automatically exits to the product name.
Cabletron
Hardware Init Cabletron
Boot From Flash
Cabletron
BOOTP Discovery Cabletron
RARP Req. State
Cabletron
TFTP Req. State Cabletron
TFTP in Progress
Cabletron
TFTP Complete Cabletron
Erasing Flash
Cabletron
Programming Flash Cabletron
Flash Programmed
Cabletron
Boot Complete Cabletron
Test in Progress
NOTE
Whether you are displaying Static System messages, Alarm
messages, or Saved System messages, the display returns to
the product name display 20 seconds after the last operation of
the DISPLAY button.