Cabletron Systems NBR-420 - Manual (Page 57)

NBR-SERIES Installation Guide Page B-1
APPENDIX B
EPIM SPECIFICATIONS
B.1 EPIM SPECIFICATIONS
EPIMs enable the connection of the NBR to different media types.
Cabletron Systems offers a variety of EPIMs. The following sections
explain specifications for each EPIM.
B.2 EPIM-T
The EPIM-T is an RJ45 connector supporting UTP cabling. It has an
internal Cabletron Systems TPT-T 10BASE-T Twisted Pair Transceiver.
The slide switch on the EPIM-T determines the cross-over status of the
cable pairs. If the switch is on the
X side, the pairs are internally crossed
over. If the switch is on the = side, the pairs are not internally crossed
over. Figure B-1 shows the pinouts for the EPIM-T in both positions.
Figure B-1 Crossover Switch on the EPIM-T
Position =
(not crossed over)
1. TX+
2. TX-
3. RX+
4. NC 5. NC
6. RX-
7. NC
8. NC
Position X
(crossed over)
1. RX+
2. RX-
3. TX+
4. NC 5. NC
6. TX-
7. NC
8. NC
1092_20