Triton RSA 300 - Manual (Page 5)

5
GB
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool’s operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Safety Instructions / Assembly
ASSEMBLY
Step 1
Fit 2 Leg Clamps (H) to each Side Frame (E) using
the Coach Bolts (J), Leg Clamp Springs (I) and Round
Knobs (G). Ensure the feet of the leg clamps fit into the
slots on the side frame end brackets. Screw on the
knobs, just a few turns only. (FIG. 1)
Step 2
Attach the side frames to the front and rear end
panels (A & B) using the Phillips Head Screws (L) and
Flange Nuts (K), as shown. Do not tighten yet. Once all
fasteners are in position, place the unit on a flat work
surface and tighten firmly with a screwdriver
Step 3
Turn the unit upside down. Remove the Front Legs (C)
from their storage position inside the Rear Legs (D).
Insert the rear legs (with rubber feet) fully into their
sockets at the rear of the unit. Insert the front legs
fully into the front sockets. The location of the holes in
each leg is not important at this stage. Lock them by
tightening the round knobs.
Turn the router stand right way up and test that all feet
sit level on the ground. If on an uneven surface make
any necessary adjustments by extending one of the
legs slightly from its socket to prevent the unit from
rocking.
Storing the legs
The legs have a convenient onboard storage location.
Loosen the round knobs and remove the legs from
their sockets. Slide the front legs inside the rear legs,
ensuring that the holes in each tube line up. Insert the
legs through the cut-outs in the rear panel and into
the cut-outs in the front panel with their holes facing
outwards (FIG. 2). Engage the holes in the legs over the
tabs on the rear panel cut-outs and rotate the latches
to lock the legs in position.